In this article, we would be discussing the Multiprotocol Label Switching (MPLS) based L2 Virtual Private Network (L2VPN) pseudowires. We would be discussing the signaling of the pseudowire and packet analysis in Cisco IOS, IOS-XE in order to illustrate the behavior. Also, if you wish to make a good career in the field of IT Department, you could do it by gaining the courses, which are being offered at the SPOTO. Why do we need the L2VPN needed?    It allows SP to have a single infrastructure for both IP as well as legacy services.    It provides Migrate legacy ATM and Frame Relay services to MPLS/IP core with no interruption to existing services.    It provides provisioning new L2VPN services which are incremental (not from scratch) in existing MPLS/IP core    It provides Capital as well as Operational savings of converged IP/MPLS network.    SP also provides new point-2-point or point-2-multipoint services. The customer could have their own routing, security mechanisms, QoS policies, etc. Layer 2 (L2) transport over MPLS and IP already exists for like-to-like attachment circuits, such as Ethernet-to-Ethernet, PPP-to-PPP, High-Level Data Link Control (HDLC), etc. L2VPNs employ L2 services over MPLS in order to build a topology of point-to-point connections that connect end customer sites in a VPN. These L2VPNs provide an alternative to private networks that have been provisioned by means of dedicated leased lines or by means of L2 virtual circuits that employ ATM or Frame Relay. The service provisioned with these L2VPNs is known as Virtual Private Wire Service (VPWS).    L2VPNs are built with Pseudowire (PW) technology    PWs provide a common intermediate format to transport multiple types of network services over a Packet Switched Network (PSN) – a network that forwards packets – IPv4, IPv6, MPLS, Ethernet    PW technology would also provide Like-to-Like transport and also Interworking (IW)    Frames that are received at the PE router on the AC are encapsulated and sent across the PSW to the remote PE router.    The egress PE router receives the packet from the PSW and removes their encapsulation.    The egress PE extracts and forwards the frame to the AC VPWS - Pseudo Wire Reference Model    PW is a connection between two PE devices which connects two ACs, carrying L2 frames    Any Transport Over MPLS (AToM) is Cisco’s implementation of VPWS for IP/MPLS   networks.    Attachment Circuit (AC) is the physical or virtual circuit attaching a CE to a PE, can be ATM, Frame Relay, HDLC, PPP and so on.    Customer Edge (CE) equipment perceives a PW as an unshared link or circuit Signaling the Pseudowire    A TLDP session amid the PE router signals the Pseudowire.    A T-LDP session between the PE routers is to advertise the VC label that is associated with the PSW.    This label would be advertised in a label mapping message so as to use the downstream unsolicited label advertisement mode.    VC label advertised by the egress PE to ingress PE for the AC over the TLDP session.  # VC Label by TLDP    Tunnel label would be able to advertise for the egress PE router to the ingress PE by LDP.  # Tunnel Label by LDP So, after you have gone through the following details regarding the MPLS L2VPN Pseudowire, but if it is not enough, you could always join some good training courses online so as to help you out in your studies. Some institutions like the SPOTO even offer you proper hands-on training for the Lab Exam, which would be very much helpful to you. SPOTO is considered to be the one-stop destination for numerous IT-related certifications, which also includes certifications offered by the CISCO.