100% Pass Cisco, PMP, ISACA, CompTIA, AWS Practice Dumps on SALE!
Get Now
Hurry to Test the Latest 300-410 Certification Exam Samples
- Which statement about IPV6 ND inspection is true? A. It learns and secures bindings for stateless autoconfiguration addresses in Layer 2 neighbor tables. B. It learns and secures bindings for stateful autoconfiguration addresses in Layer 2 neighbor tables. C. It learns and secures bindings for stateful autoconfiguration addresses in Layer 3 neighbor tables D. It learns and secures bindings for stateless autoconfiguration addresses in Layer 3 neighbor tables. Correct Answer: A
- While working with software images, an engineer observes that Cisco DNA Center cannot upload its software image directly from the device. Why is the image not uploading? A. The device has lost connectivity to Cisco DNA Center. B. The software image for the device is in install mode. C. The software image for the device is in bundle mode. D. The device must be resynced to Cisco DNA Center. Correct Answer: C 3. When provisioning a device in Cisco DNA Center, the engineer sees the error message "Cannot select the device. Not compatible with template". What is the reason for the error? A. The template has an incorrect configuration. B. The changes to the template were not committed. C. The tag that was used to filter the templates does not match the device tag. D. The software version of the template is different from the software version of the device. Correct Answer: C
- Which list defines the contents of an MPLS label? A. 20-bit label; 3-bit flow label; 1-bit bottom stack, 8-bit hop limit B. 20-bit label; 3-bit traffic class; 1-bit bottom stack, 8-bit TTL C. 32-bit label; 3-bit traffic class; 1-bit bottom stack, 8-bit TTL D. 32-bit label; 3-bit flow label; 1-bit bottom stack, 8-bit hop limit Correct Answer: B
- Which transport layer protocol is used to form LDP sessions? A. UDP B. TCP C. SCTP D. RDP Correct Answer: B 6. Which command allows traffic to load balance in an MIPLS Layer 3 VPN configuration? A. multi-paths eibgp 2 B. multi-paths 2 C. maximum-paths 2 D. maximum-paths ibgp 2 Correct Answer: A 7. An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.) A. Copy the file to the destination router with the copy tftp: flash: command. B. Configure the TFTP authentication on the source router with the tftp-server authentication local command. C. Configure a user on the source router with the username tftp password tftp command. D. Enable the TFTP server on the source router with the tftp-server flash: <filename> command. E. TFTP is not supported in recent IOS versions, so an alternative method must be used. Correct Answer: AD 8. What is a prerequisite for configuring BFD? A. To use BFD with BGP, the timers 3 9 command must first be configured in the BGP routing process. B. Jumbo frame support must be configured on the router that is using BFD. C. All routers in the path between two BFD endpoints must have BFD enabled D. Cisco Express Forwarding must be enabled on all participating BFD endpoints. Correct Answer: D 9. Which method changes the forwarding decision that a router makes without first changing the routing table or influencing the IP data plane? A. nobroadcast multiaccess B. packet switching C. policy-based routing D. forwarding information base Correct Answer: C 10. Which protocol is used to determine the NBMA address on the other end of a tunnel when mGRE is used? A. IPsec B. MP-BGP C. NHRP D. OSPF Correct Answer: C